Any job that moves dirt in north Atlanta carries the same risk: the first hard storm takes a share of your soil down the driveway, into the street, and from there into a creek. A silt fence is the simplest defense against that, and it is also the thing most often put in wrong.

Georgia has a written standard for this, and it is worth knowing even if you are not the one installing it. The Georgia Soil and Water Conservation Commission field manual sets out how a silt fence is supposed to be built, where it can go, and when it has to be cleaned out. Most of the sagging fences you see along a construction edge fail at least two of those.

What a silt fence is actually for

A silt fence is a sediment barrier, not a water barrier. Water passes through the fabric; soil particles do not. That only works for sheet flow, the thin film of water that moves evenly down a slope after rain. The manual is explicit that these barriers are not to be installed across streams, ditches, waterways or any other concentrated flow area. Run one across a swale that carries water in a storm and the flow will either go round the end or take the fence with it.

The fabric is a geotextile, and the woven against non-woven question matters here for the same reason it matters behind a wall: flow rate set against what the fabric holds back.

How far up the slope one fence can hold

This is the number nobody checks. The manual limits the continuous slope length behind a silt fence according to how steep the ground is: 100 feet where the land falls at less than 2 percent, 75 feet at 2 to 5 percent, 50 feet at 5 to 10 percent, 25 feet at 10 to 20 percent, and 15 feet on anything steeper than 20 percent. North Atlanta yards are not flat. On a back slope dropping toward a creek, one line of fence at the bottom is doing the work of three, which is why it ends up buried by March.

Installing it so it works

  • The fabric is keyed into the ground, not laid on it. The manual gives a trench 2 to 6 inches wide with a 6 inch excavation, or a 12 inch slit cut with a static slicing machine and the fabric placed in behind the blade.
  • Posts are driven at least 18 inches into the ground, from a post at least 4 feet long.
  • Spacing depends on what sits downhill: no more than 4 feet on center in sensitive areas, no more than 6 feet in non-sensitive ones.
  • Type C fabric carries wire reinforcement or equivalent backing. Type A and Type C fabric are 36 inches wide, Type B is 22.
  • The ends get turned uphill. A fence that stops dead at a property line funnels everything around its end and does nothing.

The part everybody skips

A silt fence is not a set-and-forget item. The manual says to remove accumulated sediment once it reaches one half the original height of the barrier, and to replace the barrier when it has deteriorated, which it puts at around six months, or when its standing height drops below 80 percent of what it was installed at. A fence left until it is buried to the top is no longer a sediment barrier. It is a dam, and it fails sideways.

The buffer you cannot touch

If there is a creek on or near the property, there is a line you do not cross. Georgia law sets an undisturbed buffer of 25 feet along warm water state waters, and Georgia EPD grants exceptions to it only by written variance, which tells you how seriously it is treated. Plenty of back yards in Brookhaven and Sandy Springs run down to a tributary of Nancy Creek or Peachtree Creek without the owner thinking of it as a state water. It is one.

Whether a particular job needs a written erosion control plan or a land disturbance permit is a local question, and the answer differs between DeKalb, Fulton and the cities inside them, much as wall heights do. Ask your county or city before the first shovel rather than after a neighbor calls.

What we do on our own jobs

The fence goes in before the machine does, not after the first rain has made the point. It gets trenched rather than laid. Ends turned up. Where a slope is long enough to need it, a second line part way up instead of one heroic line at the bottom. Inlet protection on any street drain below the work. And at the end of the job the fence comes out, because fabric left in a planting bed for two years is just litter with stakes in it.

The sustainability case here is a plain one. Soil that stays on your site is soil you do not buy back, and it is not sitting in the creek behind the house either. Stripping the topsoil, stockpiling it under cover and putting it back at the end of the job beats hauling it off and importing new, every time.

If you have work coming up and you are not sure what the yard does in a storm, get in touch and we will walk it with you. More on water and grading in our drainage work, on what belongs behind a retaining wall, and the rest of the guides.

Leave a Reply

Call (404) 369-0989 Free site visit